Refresh Timeout Limit
Some refresh operations may take a long time due to one or more of the following factors:
• The device has a very large routing table.
• There is a very high load on the CPU running LiveNX.
• The device is connected to LiveNX over a high-latency path.
If the route display refresh is not completed within 30 seconds, LiveNX will time out and show an error message. If this happens, reduce the load by limiting the refresh operation to specific routes that match the specified IP address and mask pair prefix, rather than refreshing all routes.
NOTE: The refresh operation applies only to the display, and does not affect the device’s configuration or any of the routes themselves.